For new Quantum Radome installations where communications will be carried via cable, it is recommended that the Quantum Radome be purchased without a Data cable and that a Digital Radar Cable (single cable supplies power and Ethernet communications) be chased between the radome and the MFD or HS5 RayNet Network Switch.

I purchased a Quantum Wifi Radar (Q24W) from the Raymarine/FLIR online store. It arrived last week and I tried to install it last night. The hardware all went in relatively easily, no issues, and, I wired it directly to a 12v power source. The problem I'm having is that it won't connect to either one of my Axiom 9 MFD's.

Quantum Wireless Radar T70166. Installed new in July 2017. It seemed to be working fine, however hardly needed to use it except for occasionally having it on to get used to the display. Last summer we were in thick fog, and of course it failed. First it would not turn on. I had to turn the power off and on a couple of times to get it to respond.

Welcome to the Raymarine Forum MAK1377, It is recommended that you first verify that the Quantum radome has been updated with the latest available Raymarine product software update, as the initially released software could trigger the reported symptoms. If it has been updated with the latest software, then it is recommended that the vessel be ...

Welcome to the Raymarine Forum Istream, Whether interfacing with a Quantum radome via a wired Ethernet connection or via Wi-Fi, it is recommended that Quantum radomes be powered from a dedicated switched power circuit to permit the radome to be restarted without affecting the power state of the system's other marine electronics products.

2017年5月3日 · The Quantum Wifi radar was reconnected again via Wifi The radar connected without problems and with WPA encryption on the MFD enabled. As i said, my neighbour had the same problem, the above is also applied to his MFD. What I have not checked is wether an iPad will connect with the same encryption settings, when operating the radar.

2. Verify that the Quantum/Quantum 2 radome has been updated with the latest available Raymarine product software update. Note that this may not be possible if MFD is unable to communicate with the radome. 3. Perform the Wi-Fi site survey called for within the Quantum/Quantum 2 Radome Installation Instructions.

Dave, Until there's more feedback regarding the improvements in waking a Quantum/Quantum 2 radome from sleep mode it will remain my recommendation to ensure that any radar transducer (radome or open array pedestal) has been powered from a dedicated power circuit which may be switched ON/OFF without affecting the power state of the system's other marine electronics …

The Quantum radome would typically be paired to the cockpit display on sailing vessels lacking a below decks helm station, as the Quantum radar would not typically operated unless the vessel is underway with a lookout in the cockpit (Rule 5 of the USCG NAVIGATION RULES AND REGULATIONS). Q2. Can I connect both MFDs with a RayNet to RayNet Cable ...

2017年11月1日 · RE: Quantum Radar Issue Unfortunately, the recommendations of the referenced FAQ did not correct my issue. The Radome has power and establishes a connection just fine, however when attempting to transmit it fails the scanner self test and does not allow continuing or an option to correct, only to shut down the radar.